HP StorageWorks XPath OS 7.4.X Command Reference Guide (AA-RVHCC-TE, September 2005)

48 XPath OS CLI commands
This command cannot be executed on an enabled system; you must first disable the system using the
switchDisable command.
See Chapter 2 for more information.
Operands
none
Examples
To configure the fabric-related MP Router configuration parameters:
See also
configDefault
configShow
switchDisable
switchEnable
End-device RSCN
Transmission Mode
This specifies the transmission mode of registered state change
notification (RSCN) extended link service (ELS) to the end
devices:
0 Single process ID (PID) for each payload
1 Multiple PIDs for each payload
2 Fabric-format RSCN only
switch:admin> configure
Fabric parameter set. <cr> to skip a parameter
Domain: (1..239 or f(fabric_assign)) [100 unconfigured]
BB Credit: [1..32] [16]
R_A_TOV: (4000..120000) [10000]
E_D_TOV: (1000..5000) [2000] 2500
Data field size: (256..2112) [2112]
Switch PID Address Mode (1..2) [2]
WAN_TOV (1000..R_A_TOV/4 ) [0]
MAX_HOP_COUNT (7..19 ) [7]
End-device RSCN Transmission Mode (0..2) [1]
Fabric configuration set
You must run switchenable to return the switch back to running state.