HP StorageWorks XPath OS 7.4.X Command Reference Guide (AA-RVHCC-TE, September 2005)

202 XPath OS CLI commands
Operands
This command has the following required operand:
Examples
To display information about port 1, which is in point-to-point mode:
EX_Port
Enabled The port is configured to be an EX_Port.
Disabled No EX_Port is displayed if the port is not configured to be
an EX_Port.
Fabric ID The fabric ID assigned to this EX_Port, which is the edge
fabric attached to this EX_Port.
Fabric params The fabric parameters for port negotiation with the
neighbor E_Port in the EX_Port-attached edge fabric.
Fabric parameters include R_A_TOV, E_D_TOV, and Port
ID format.
Front Phantom Front phantom domain information presented by the
EX_Port, including the preferred (nonactive) or actual
(active) domain ID and WWN for the front domain.
Pr Switch Info Information on the principal switch of the edge fabric
attached to the EX_Port, including the domain ID and
WWN of the principal switch.
Licensed
YES Port is licensed.
NO Port has failed diagnostics.
Diag Result
PASSED Port has passed diagnostics.
FAILED Port has failed diagnostics.
Protocol Applies only to GbE ports. The supported protocol is FCIP.
port Specifies the port.
switch:admin> portshow 1
port 1 info
Configuration Current
Name : port_1
State: STARTED UP
Type : FC FC
Link Status: ENABLED UP
Topology: P-P P-P
Speed: AN 2G
LinkCost: 800 (STATIC)
WWN: 20:01:00:05:1e:13:55:00
Licensed : YES
(continued on next page)