HP StorageWorks XPath OS 7.4.X Command Reference Guide (AA-RVHCC-TE, September 2005)

198 XPath OS CLI commands
Displays port throughput numbers.
Synopsis
portperfshow [interval]
Availability
all users
Description
Use this command to display port throughput numbers for all ports on the MP Router. One output line is
displayed every five seconds (or longer if interval is specified) until you press Ctrl-C. The command
and port number heading is repeated every 16 lines.
The Total column displays the sum of all throughput values of all ports.
The numbers displayed represent the number of bytes received and the number of bytes transmitted per
second. Throughput numbers are displayed as either bytes/second, kilobytes/second (the number is
followed by k), megabytes/second (the number is followed by m), or (for Total column alone)
gigabytes/second (the number is followed by g).
This information is used to monitor port performance.
Operands
This command has the following optional operand:
Examples
To display port throughput numbers for all ports on the MP Router at the default display interval of
5seconds:
portPerfShow
interval The interval, in seconds, between each sample. The minimum
interval allowed is 5 seconds. If an interval is not specified, a
default interval of 5 seconds is used.
switch:admin> portperfshow
Data Sampled every 5 seconds.
portperfshow 5
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Total
FC FC FC FC FC FC FC FC FC FC FC FC FC FC FC FC
--------------------------------------------------------------------------------------
0 0 0 0 0 0 0 0 185m 0 0 185m 0 0 0 0 371m
0 0 0 0 0 0 0 0 189m 0 0 189m 0 0 0 0 379m
0 0 0 0 0 0 0 0 186m 0 0 186m 0 0 0 0 373m
0 0 0 0 0 0 0 0 186m 0 0 186m 0 0 0 0 373m
0 0 0 0 0 0 0 0 188m 0 0 188m 0 0 0 0 377m
0 0 0 0 0 0 0 0 189m 0 0 189m 0 0 0 0 379m
0 0 0 0 0 0 0 0 189m 0 0 189m 0 0 0 0 379m
(continued on next page)