HP StorageWorks XPath OS 7.4.X Command Reference Guide (AA-RVHCC-TE, September 2005)

170 XPath OS CLI commands
Examples
To display the FCIP configuration of port 3:
To set the IP address of port 1 to 10.1.1.1:
See also
linkCost
portCfgEPort
portCfgSpeed
portCfgTopology
portDisable
portEnable
portShow
portType
-b bandwidth If the available bandwidth for FCIP is low, set the value (Mbit/sec)
to accomplish better bandwidth utilization. Valid values are 1 to
1000.
-m load_balance_mode Sets the load balance mode as follows:
1 Exchange
2 SIL_DID
3 None
The default is exchange mode.
switch:admin> portcfgfcip 3
admin status : ENABLED
ipaddress : 1.1.3.1
wwn : 00:00:00:00:00:00:00:00
Link Available Bandwidth : 1000
Jumbo Support is enabled
WAN_TOV enforcement is disabled
switch:admin> portcfgfcip 1 -i 10.1.1.1
port 1 ipaddress is set to: 10.1.1.1