HP StorageWorks XPath OS 7.4.X Command Reference Guide (AA-RVHCC-TE, September 2005)

XPath OS 7.4.x command reference guide 169
Displays or sets the FCIP port configuration.
Synopsis
portcfgfcip slot-port-range [-i ipaddress] [-a admin] [-w wwn]
[-t timeout_enforcement] [-j jumbo_support][-b bandwidth]
[-m load_balance_mode {1-, 2-, 3-none}]
Availability
admin
Description
Use this command to display or set the FCIP port IP configuration. If no optional parameter is given, this
command displays the currently configured value; otherwise, it sets the specified attributes to the new
value.
Operands
This command has the following required operand:
This command has the following optional operands:
portCfgFcip
slot-port-range Identifies the slot, port, or range of ports.
-i ipaddress Sets the remote IP address.
-a admin Activate or deactivate FCIP as follows:
1 Activate
2 Deactivate
-w wwn Sets the remote WWN. If the remote WWN is configured, the MP
Router accepts only the incoming FCIP tunnel with the configured
WWN; it also only initiates a tunnel to the desired MP Router. If
the remote WWN is not configured, the MP Router accepts FCIP
connections from any other MP Router.
-t timeout_enforcement Controls whether or not the FCIP link enforces packet timeouts. If
configured for timeout enforcement, each outgoing packet is
stamped with the current time. Each incoming packet uses the
received timeout to determine if the packet should be dropped.
The packet’s timestamp and the MP Router’s configured
WAN_TOV values are compared against the current time. If the
packet has been in transit for longer than the configured
WAN_TOV time period, the packet is dropped.
Enable or disable timeout enforcement as follows:
1 Enable
2 Disable
-j jumbo_support If the network supports jumbo frames (2K max FC frame), use the
-j operand to enable jumbo support on the MP Router.
Activate or deactivate jumbo support as follows:
1 Activate
2 Deactivate