HP StorageWorks XPath OS 7.4.X Command Reference Guide (AA-RVHCC-TE, September 2005)

102 XPath OS CLI commands
Operands
This command has the following operands:
Examples
To display persistent proxy device configuration:
To persistently configure device WWN 00:11:22:33:44:55:66:77 to use slot f101h in fabric 5:
-s importedFID devWWN slot The -s option adds the specified WWN (format:
xx:xx:xx:xx:xx:xx:xx:xx) to the specified slot (format xxyyh,
where xx is the translate domain port number, yy is the AL_PA)
for the edge fabric specified (1 to 128).
An error message could be displayed, depending on the
condition that caused the error, as follows:
• If the WWN does not exist in any slot for the specified edge
fabric, this message is displayed:
WWN does not exist in any proxy device
slot.
• If all slots are used for the specified edge fabric, this
message is displayed:
Too many proxy slots configured. Remove
some unused proxy device WWNs from their
slots using the -r option and try again.
• If the specified slot already contains an entry, this message
is displayed:
The specified slot already contains a WWN,
overwrite?(y)
-r edgeFID WWN The -r option removes the specified WWN (format:
xx:xx:xx:xx:xx:xx:xx:xx) from its slot for the edge fabric
specified by edgeFID (1 to 128).
The following message displays if the WWN does not exist in
any slot for the specified edge fabric:
WWN does not exist in any proxy device
slot.
fcr:admin> fcrproxyconfig
Edge FID Device WWN Slot
002 50:05:07:65:05:84:08:d7 f001
002 50:05:07:65:05:84:0a:7b f002
002 22:00:00:20:37:c3:11:71 f001
002 22:00:00:20:37:c3:1a:8a f002
003 10:00:00:00:c9:2b:6a:2c f001
004 10:00:00:00:c9:2b:6a:2c f001
fcr:admin> fcrproxyconfig -s 5 00:11:22:33:44:55:66:77, f101