HP StorageWorks XPath OS 7.4.X Administrator Guide (AA-RVHDD-TE, February 2006)

64 Using the FC-FC Routing Service
6. Issue the cfgEnable command to enable the zone configuration.:
7. Optional: Reissue the cfgShow command to verify that the zoning is correct.:
Alternately, use the following procedure:
1. Create a telnet or Advanced Web Tools connection to the HP StorageWorks switch.
2. Configure the LSAN, using the LSAN_xxxx naming schema, and append the new LSAN to the active
zoneset.
3. Enable zone configuration that now includes the new LSAN.
Configuring the McDATA fabric for interconnection
To ensure connectivity with the HP fabric, the McDATA fabric must be prepared for use with the MP Router.
Either of the following procedures may be used.
NOTE: The procedures described in this section were current when the document was written, but may
have changed slightly since then. For the most up-to-date information, see the McDATA documentation
about zone configuration on McDATA fabrics.
1. Log in to SAN Pilot or EFCM (see Figure 8).
ED5000 uses only EFCM.
2. From the Configure menu, select Zones (Zoning Library on EFCM).
3. Tab to Zones.
switch:admin> cfgenable "Domain1"
zone config "Domain1" is in effect
Updating flash ...
switch:admin> cfgshow
Defined configuration:
cfg: Domain1 LSAN_1
zone: LSAN_1 lsan_host_1; lsan_host_2
alias: lsan_host_1
10:00:00:00:c9:08:05:00
alias: lsan_host_2
10:00:00:00:c9:08:04:00
Effective configuration:
cfg: Domain1
zone: LSAN_1 10:00:00:00:c9:08:05:00
10:00:00:00:c9:08:04:00