HP StorageWorks SAN Switch Rack Mount Kit Installation Instructions (AV-RU6YD-TE, September 2004)

9SAN Switch Rack Mount Kit Installation Instructions
— For an HP System/e rack, install each of the two rear mounting brackets
with two #10-32 x 1/2-inch Phillips pan-head screws and two #10
alignment washers as shown in Figure 2.
Figure 2: Installing the Rear Mounting Brackets (HP System/e Rack-Left Rear
Upright)
Note: This kit contains both left rails and right rails. The rails are labelled Right and
Left.