HP StorageWorks SAN Switch Rack Mount Kit Installation Instructions (AV-RU6YD-TE, September 2004)

6 SAN Switch Rack Mount Kit Installation Instructions
Using the SAN Switch Rack Mount Kit to Install an
HP StorageWorks Device
Read this section to install a SAN Switch or MP Router in an HP Series 9000, HP
Series 10,000, or HP System/e rack.
Note: The SAN Switch Rack Mount Kit installation requires one technician.
The following items are required to install the device in a rack:
■ The HP StorageWorks MP Router or specific HP StorageWorks SAN Switch
listed in the About this Document section on page 3.
■ Power cables
■ #2 Phillips screwdriver
■ 7/16-inch wrench or socket
■ SAN Switch Rack Mount Kit hardware shown in Table 1.
Table 1: Rack Mount Kit Rails and Rail Mounting Hardware
Item Description
(2) rear mounting brackets
A right inner rail and a right outer rail
A left inner rail and a left outer rail
(14) #8-32 x 3/16-inch Phillips pan-head
screws with thread lock for the SAN Switch
2/32 only.