HP StorageWorks Fabric OS 5.2.x administrator guide (5697-0014, November 2009)

Fabric OS 5.2.x administrator guide 207
Performing verification checks
Before configuring a fabric to connect to another fabric, you must perform the following verification checks
on the switch or director.
To perform verification checks
1. Log in to the switch or director as admin and enter the version command. Verify that Fabric OS
v5.2.x is installed on the 400 MP Router or B-Series MP Router blade, as shown in the following
example.
2. If configuring the 4/256 SAN Director with a B-Series MP Router blade, enter the slotShow
command to verify that the B-Series MP Router blade is present.
See ”Configuring Directors” on page 207 for a list of blades and their corresponding IDs.
3. If configuring the 4/256 SAN Director with a B-Series MP Router blade, then enter the
chassisConfig command to verify that the director is using configuration option 5.
4. Enter the interopMode command and verify that switch interoperability with switches from other
manufacturers is disabled.
switch:admin_06> version
Kernel: 2.4.19
Fabric OS: v5.2.x
Made on: Thu Sep 21 01:15:34 2006
Flash: Fri Sep 22 20:53:48 2006
BootProm: 4.5.3
switch:admin_06> slotshow
Slot Blade Type ID Status
---------------------------------
1 SW BLADE 17 ENABLED
2 AP BLADE 24 ENABLED
3 UNKNOWN VACANT
4 UNKNOWN VACANT
5 CP BLADE 16 ENABLED
6 CP BLADE 16 ENABLED
7 SW BLADE 17 ENABLED
8 UNKNOWN VACANT
9 SW BLADE 18 ENABLED
10 UNKNOWN VACANT
switch:admin_06> chassisconfig
Current Option: 5
All Supported Options
----------------------------------------------------
Option 1: One 128-port switch
Blade ID's 4, 17 in slots 1-4, 7-10
Blade ID's 5, 16 in slots 5-6
Option 5: One 256-port switch
Blade ID's 17, 18, 24 in slots 1-4, 7-10
Blade ID 16 in slots 5-6
Please use slotshow to see Blade IDs currently in the system.
switch:admin_06> interopmode
InteropMode: Off
Usage: InteropMode 0|1
0: to turn it off
1: to turn it on