HP StorageWorks Advanced Web Tools 7.4.X Administrator Guide (AA-RVHFC-TE, September 2005)

Advanced Web Tools 7.4.x administrator guide 65
e. Click the iSCSI Names tab, select names, and click Add iSCSI Name.
You can also enter an iSCSI name in the Any iSCSI Name box and click Add.
Only iSCSI initiators are displayed. Each iSCSI initiator has a WWN assigned to it. These WWNs
are not displayed in the WWNs tab, however.
You must configure a CHAP secret for the devices in the zone to establish communication. See
”Configuring CHAP” on page 100 for more information.
f. Verify that the Zone Members to be added list contains the correct members.
g. Click Remove to remove members, if necessary.
h. Click OK.
5. To remove zone members:
a. Select the zone members to delete.
b. Click Remove Members in the Zone Members task bar.
c. Click Yes in the confirmation window.
6. To rename the zone:
d. Click Rename in the task bar.
e. Enter the new name for the zone in the New name box of the Rename Zone window.
f. Click OK.
The changes to the zone are displayed in the zone drill-down page.
Deleting a zone
You cannot delete zones that are included in the effective zone configuration. Use the following procedure
to delete a zone:
1. From the Switch Explorer, click the Zone Administration icon in the fabric toolbar, or from the Switch
Manager, click Zoning in the navigation bar.
2. Click the Zones tab.
3. Select the zone to delete.
4. Click Delete in the task bar.
5. Click Yes in the confirmation window.
Managing zone configurations
The Zone Configurations tab in the Zoning page displays a list of the zone configurations in the fabric and
provides tasks for managing those zone configurations (see Figure 24).
The effective zone configuration is designated with a check in the Effective column and an asterisk next to
the zone configuration name. You cannot alter the effective zone configuration.
A zone configuration with the same name as the effective configuration is also listed. This is a copy of the
effective zone configuration. Although you cannot alter the effective zone configuration, you can alter the
copy of the effective configuration.
From Zone Configurations tab, you can create, rename, delete, enable, disable, and clone zone
configurations. The procedures for these tasks are described next.