HP StorageWorks Advanced Web Tools 7.4.X Administrator Guide (AA-RVHFC-TE, September 2005)

Advanced Web Tools 7.4.x administrator guide 41
4. Click the Firmware tab (see Figure 15 on page 40).
5. Click Download in the task bar.
6. Optional: Click the Edit Server button to verify or change the server from which the package is to be
downloaded.
7. Select the package to download from the File drop-down list.
8. Click OK.
This process takes about fifteen minutes. Do not perform any other operation until the image download
completes.
Upon completion, you must reboot the MP Router (see ”Rebooting the MP Router” on page 38). The new
configuration takes effect after the MP Router reboots.
Repeat this procedure if there are additional firmware packages.
NOTE: Updating firmware does not change license keys, but new firmware might have new license
requirements, for example, the new firmware might include a new feature requiring a new license. Check
for changed license requirements when you update firmware.
Viewing SNMP information
This section explains how to view SNMP information and manage trap recipients. These procedures are
performed from the SNMP tab of the Administration page, which is shown in Figure 16.
The SNMP pane displays the following SNMP agent system parameters, which correspond to variables in
the MIB II system group:
• System Name corresponds to sysName.
• System Description corresponds to sysDesc.
• System Contact corresponds to sysContact.
• System Location corresponds to sysLocation.
For the Event Trap Level, when an event occurs, if its severity level is at or below the specified numeric
value, the agent sends the associated trap to the configured recipients.