Brocade Fabric Watch Administrator's Guide - Supporting Fabric OS v5.3.0 (53-1000438-01, June 2007)

62 Fabric Watch Administrator’s Guide
53-0000438-01
Viewing Fabric Watch reports
4
Viewing Fabric Watch reports
You can view Fabric Watch reports in the following ways:
• “Viewing Fabric Watch reports using telnet,” next
• “Viewing Fabric Watch reports using Web Tools” on page 62
VIEWING FABRIC WATCH REPORTS USING TELNET
To view Fabric Watch reports using telnet, start a telnet session and enter the command (from
Table 18) corresponding to the report you want to view.
VIEWING FABRIC WATCH REPORTS USING WEB TOOLS
To view Fabric Watch reports using Web Tools, connect to a switch using a web browser, and select
the report button (shown in Figure 31).
FIGURE 31 Report button
TABLE 18 Telnet commands for viewing Fabric Watch reports
Use the command To view
fwSamShow Port failure rate report
switchStatusShow Switch health report
switchStatusPolicyShow Switch status policy report
fwPortDetailShow
fwPortDetailShow --s h
fwPortDetailShow --s m
fwPortDetailShow --s f
fwPortDetailShow --s o
Port detail report
To view only health ports
To view only marginal ports
To view only faulty ports
To view only offline ports