Brocade Fabric Watch Administrator's Guide - Supporting Fabric OS v5.3.0 (53-1000438-01, June 2007)

Fabric Watch Administrator’s Guide 49
53-0000438-01
Configuring Fabric Watch using Web Tools
3
WWN 0 0
Note that the value 0 for a parameter means that it is NOT used
in the calculation
Configurable Alarm States are:
Absent-1, Inserted-2, On-4, Off-8, Faulty-16
Configurable Alarm Actions are:
Errlog-1, E-mail-16
Slot Alarm State: (0..31) [31]
Slot Alarm Action: (0..17) [1]
Power Supply Alarm State: (0..31) [0]
Power Supply Alarm Action: (0..17) [0]
Fan Alarm State: (0..31) [0]
Fan Alarm Action: (0..17) [0]
WWN Alarm State: (0..31) [0]
WWN Alarm Action: (0..17) [0]
Fru configuration left unchanged
FIGURE 23 fwFruCfg Configuration
You can specify triggers for any number of alarm states or alarm actions. The first prompt enables
you to select which FRU states trigger events.
To select a group of FRU states:
1. Add the numbers beside each state (for the states you want to include).
2. Enter the total at the prompt.
For example, to trigger events using the Absent, Off, and Faulty states, add the assigned values
and enter that value at the prompt. In this case, the values are 1, 8, and 16, respectively, and the
total is 25.
Configuring Fabric Watch using Web Tools
To configure Fabric Watch using Web Tools, see the Web Tools Administrator’s Guide.
Configuring Fabric Watch using SNMP
NOTE
The instructions given in this procedure apply to the AdventNet MIB browser. The procedure might
vary if you use other MIB browsers.