Brocade Fabric OS MIB Reference - Supporting Fabric OS 5.3.0 (53-1000439-01, June 2007)

224 Fabric OS MIB Reference
53-1000439-01
connUnitPortControl 1.3.6.1.3.94.1.10.1.16
8
- A request (NON-PARTICIPATING) command to the loop port state machine.
- Removal of the port from an arbitrated loop by a hub.
• unbypassConnUnitPort
If the addressed connUnit allows this operation to be performed to this port, the addressed
port performs a vendor-specific “unbypass” operation. Examples of these operations are
- The Link Failure protocol.
- A request (PARTICIPATING) command to the loop port state machine.
- Addition of the port to an arbitrated loop by a hub.
• offlineConnUnitPort
If the addressed connUnit allows this operation to be performed to this port, the addressed
port performs a vendor-specific offline operation.
Examples of these operations are:
- Disabling a port's transceiver.
- The Link Failure protocol.
- Request (NON-PARTICIPATING) command to the loop port state machine removal of the
port from an arbitrated loop by a hub.
• onlineConnUnitPort
If the addressed connUnit allows this operation to be performed to this port, the addressed
port performs a vendor-specific online operation.
Examples of these operations are:
- Enabling a port's transceiver.
- The Link Failure protocol, request (PARTICIPATING) command to the loop port state
machine.
- Addition of the port from an arbitrated loop by a hub.
Each implementation might choose not to allow any or all of these values on a SET.
If the management station uses in-band communication (FC-IP) with the switch, either of
the two following actions might result in a loss of in-band communication with the switch:
• Disabling the FC port that is connected to the management station
• Disabling the embedded port
• Return values are:
- resetConnUnitPort portDisable (F or E_Port, loop for U_Port)
- bypassConnUnitPort portDisable (FL_Port)
- unbypassConnUnitPort portEnable (FL_Port)
- offlineConnUnitPort portDisable (E, F, FL_Port)
- onlineConnUnitPort portEnable (U)
- resetConnUnitPortCounters clear the port statistics counter. When rebooted, this
defaults to 1 (unknown).