HP StorageWorks 2000 Family Modular Smart Array chassis and midplane replacement instructions (508267-001, January 2009)

Page 4

Installing controller modules

1. Loosen the thumbscrews; press the latches downward.

2. Slide the controller into the enclosure as far as it will go (1).

3. Press the latches upward to engage the controller (2); turn the

thumbscrews finger-tight.

Removing I/O modules

1. Turn the thumbscrews until the screws disengage from the I/O

module.

2. Press both latches downward to disconnect the I/O module from

the midplane.

3. Pull the I/O module straight out of the enclosure.

Installing I/O modules

1. Loosen the thumbscrews; press the latches downward.

2. Slide the I/O module into the enclosure as far as it will go (1).

3. Press the latches upward to engage the I/O module (2); turn the

thumbscrews finger-tight.

Verifying component installation

• Reconnect cables and power on the system and associated data

host in the following order:

a. Drive enclosure first

b. Controller enclosure next

c. Data host last

• On the drive modules, check that the Online/Activity LED is

green. For 2.5-inch drives, this LED is on the left; for 3.5-inch

drives, this LED is on the bottom.

• On the power supply modules, check that the Input Power Source

Good LED (top) is on.

• On the controller and I/O modules, check that the OK LED

(back) illuminates green, indicating that the module has

completed initializing and is online.

Additional information

See the MSA web site: http://www.hp.com/go/msa.

Service