HP StorageWorks 2000 Family Modular Smart Array chassis and midplane replacement instructions (508267-001, January 2009)

Page 3
3.5-inch modules
NO TE: 3.5-inch air management modules are installed using
the same procedure as installing 3.5-inch drive modules.
1. Push the latch release button to the right.
2. Slide the drive module into the drive slot as far as it will go.
3. Rotate the latch toward the right until it clicks closed.
Removing power supply modules
1. Turn the thumbscrew until it is disengaged from the module.
2. Rotate the latch downward to disconnect the internal connector,
and slide the module out.
Installing power supply modules
1. Slide the module into the slot as far as it will go.
2. Press the latch upward to engage the module; turn the
thumbscrew finger-tight.
Removing controller modules
1. Turn the thumbscrews until the screws disengage from the
controller.
2. Press both latches downward to disconnect the module from the
midplane.
3. Pull the module straight out of the enclosure.