HP StorageWorks 2000 Family Modular Smart Array chassis and midplane replacement instructions (508267-001, January 2009)

Page 2
2.5-inch drives
1. Press down on the latch release button.
2. Lift the latch until it is fully open, and then pull the module straight
out of the enclosure.
3.5-inch drive modules
NO TE: 3.5-inch air management modules are removed using
the same procedure as removing 3.5-inch drive modules.
1. Press and slide the release latch button to the right.
2. Pull the latch out to disengage the drive.
3. Pull the module straight out of the enclosure.
Installing drive modules
2.5-inch drive modules
1. Press down on the latch release button, and then lift the latch
until it is fully open.
2. Slide the drive module into the drive slot as far as it will go.
3. Rotate the latch downward until the latch clicks closed.