Hp StorageWorks 2000 Family Modular Smart Array CLI reference guide (481600-002, May 2008)

Chapter 3 Command Descriptions 235
show volume-maps
Description
Shows mapping information for a specified volume or for all volumes.
Input
Output
show volume-maps [volume]
Parameter Description
volume Optional. Specifies the volume by its name or serial number. For the
syntax to use, see “Volume Syntax” on page 26. If this parameter is
omitted, information for all volumes is shown.
Field Description
SN Volume serial number.
Name Volume name.
CH Host ports that the volume is mapped on.
ID FC and iSCSI only. An index into a table of port IDs (not the actual
port ID). This is always 0.
LUN Logical unit number.
Access Access mode: read-write (rw) or read-only (ro).
Host-Port-
Identifier
• FC or SAS: The host’s world wide port name (WWPN)
• iSCSI: The iSCSI host initiator’s node name (typically the IQN)
• all other hosts for the volume’s default mapping
Nickname Host nickname, or blank if not set or for all other hosts.