Hp StorageWorks 2000 Family Modular Smart Array CLI reference guide (481600-002, May 2008)

Chapter 3 Command Descriptions 169

show debug-log

Description

Note – This command should only be used by service technicians, or with the

advice of a service technician.

Shows the debug logs for the Storage Controller (SC), the Management Controller

(MC), the semaphore trace, task logs, or all of them. If no parameters are specified,

all logs are shown.

Input

show debug-log mc [mc-entries]

show debug-log sem-trace-log [sem-entries]

show debug-log task-log [task-entries]

show debug-log [all]

Parameter Description

mc Specifies to show MC debug logs.

mc-entries Optional. Specifies the number of MC logs

to show, which is recommended because

debug logs can be very large.

sc Specifies to show SC logs only.

controller a|b|both Specifies whether to show SC debug logs

for controller A, B, or both.

region boot|error|debug|all Specifies the type of SC logs to show:

• boot: Shows only the boot log.

• error: Shows only error logs recorded

for previous SC crash or improper

shutdown.

• debug: Shows only debug logs.

• all: Shows all logs.

sem-trace-log Specifies the semaphore trace log.