Hp StorageWorks 2000 Family Modular Smart Array CLI reference guide (481600-002, May 2008)

130 HP StorageWorks 2000 Family Modular Smart Array CLI reference guide • May 2008
set host-parameters
Description
FC and iSCSI only. Sets parameters for communication between controllers and
hosts. The new settings take effect without restarting the controllers.
Input
set host-parameters [controller a|b|both] [speed speed] [channel
#|all] [fibre-connection-mode loop|point-to-point] [IP address]
[netmask address] [gateway address] [noprompt]
Parameter Description
controller a|b|both Optional. Specifies whether to apply the settings to
controller A, B, or both. Required if either speed
or fibre-connection-mode is specified.
speed speed Optional. FC only. Sets the link speed in Gbit/sec.
When host port interconnects are enabled, the
speed is also changed for interconnected port on
the other controller. Valid values are 2g and 4g.
channel #|all Optional. Specifies a host port number. If this
parameter is omitted, all host ports on the specified
controllers are affected.
fibre-connection-mode
loop|point-to-point
Optional. FC only. Sets the topology for the
specified channels on the specified controllers to
either:
• loop: Fibre Channel-Arbitrated Loop (public or
private).
• point-to-point: Fibre Channel point-to-
point. Point-to-point topology is only valid and
allowed when port interconnects are disabled
(using set host-port-interconnects).
noprompt Optional. Specifies an automatic response to the
confirmation prompt that enables the operation to
proceed. If this parameter is omitted, you must
reply to the prompt.