Hp StorageWorks 2000 Family Modular Smart Array CLI reference guide (481600-002, May 2008)

Chapter 3 Command Descriptions 47
clear expander-status
Description
Note – This command should be used only by service technicians, or with the
advice of a service technician.
Clears the counters and status for SAS expander lanes. Counters and status can be
reset to a good state for all enclosures, or for a specific enclosure whose status is
Error as shown by the show expander-status command.
Input
Example
Clear the expander status for the controller enclosure.
Related Commands
■ “show expander-status” on page 184
■ “set expander-fault-isolation” on page 125
■ “set expander-phy” on page 127
clear expander-status [enclosure id]
Parameter Description
enclosure id Optional. Specifies the enclosure number, as shown by the
show expander-status command.
# clear expander-status enclosure 0
Success: Cleared Expander Status