Hp StorageWorks 2000 Family Modular Smart Array CLI reference guide (481600-002, May 2008)

122 HP StorageWorks 2000 Family Modular Smart Array CLI reference guide • May 2008
set debug-log-parameters
Description
Note – This command should only be used by service technicians, or with the
advice of a service technician.
Sets the types of debug messages to include in the Storage Controller debug log. If
multiple types are specified, use spaces to separate them and enclose the list in
quotation marks (
").
Input
set debug-log-parameters message-type+|- [...]
Parameter Description
message-type+|- Specifies one of the following message types, followed by a
plus (+) to enable or a minus (-) to disable inclusion in the
log:
• awt: Auto-write-through feature debug messages
• bkcfg: Internal configuration debug messages
• cache: Cache debug messages
• capi: Internal CAPI debug messages
• capi2: Internal CAPI tracing debug messages
• disk: Disk interface debug messages
• dms: Snapshot feature debug messages
• emp: Enclosure Management Processor debug messages
• fca: FC only. I/O interface driver debug messages
(standard)
• fcb: FC only. I/O interface driver debug messages
(resource counts)
• fcc: FC only. I/O interface driver debug messages (upper
layer, verbose)
• fcd: FC only. I/O interface driver debug messages (lower
layer, verbose)
• fo: Failover/recovery debug messages
• fruid: FRU ID debug messages
• host: Host interface debug messages