HP StorageWorks 2000 Family Modular Smart Array chassis and midplane replacement instructions (481596-001, March 2008)

Page 4

Installing I/O modules

1. Loosen the controller’s thumbscrews; press the latches downward.

2. Slide the I/O module into the enclosure as far as it will go (1).

3. Press the latches upward to engage the I/O module (2); turn the

thumbscrews finger-tight.

Verifying component installation

• Reconnect cables and power on the system and associated data

host in the following order:

a. Drive enclosure first

b. Controller enclosure next

c. Data host last

• On the power-and-cooling modules, check that the AC Power

Good LED (top) is on.

• On the controller and I/O modules, check that the OK LED

(back) illuminates green, indicating that the module has

completed initializing and is online.

Additional information

See the MSA web site: http://www.hp.com/go/msa.

Service