HP StorageWorks 2000 Family Modular Smart Array chassis and midplane replacement instructions (481596-001, March 2008)

Page 3

2. Press both latches downward to disconnect the module from the

midplane.

3. Pull outward on the latches to slide the module out of the

enclosure.

Installing controller modules

1. Loosen the controller’s thumbscrews; press the latches downward.

2. Slide the controller into the enclosure as far as it will go (1).

3. Press the latches upward to engage the controller (2); turn the

thumbscrews finger-tight.

Removing I/O modules

1. Turn the thumbscrews (2) until the screws disengage from the I/O

module.

2. Press both latches downward to disconnect the I/O module from

the midplane.

3. Pull outward on the latches to slide the I/O module out of the

enclosure.

1 Latch 2 Thumbscrew

Service

12 1 2

Service