HP StorageWorks 2000 Family Modular Smart Array chassis and midplane replacement instructions (481596-001, March 2008)

Page 2

1. Press and slide the release latch button to the right to disengage

the latch.

2. Pull the latch out toward the left to disengage the drive module

from the enclosure’s internal connector.

3. Wait 20 seconds for the internal disks to stop spinning, and pull

the drive module out of the enclosure.

Installing drive modules

1. Push the release latch button to the right to open the locking

mechanism.

2. Slide the drive module into the drive slot as far as it will go.

Removing power-and-cooling modules

1. Turn the thumbscrew (1) until it is disengaged from the

power-and-cooling module.

2. Rotate the latch (2) downward to disconnect the power module

from the internal connector, and slide it out from the slot (3).

Installing power-and-cooling modules

1. Slide the power-and-cooling module into the slot as far as it will

go.

2. Press the latch upward to engage the power-and-cooling module;

turn the thumbscrews finger-tight.

Removing controller modules

1. Turn the thumbscrews (2) until the screws disengage from the

controller.

1 Release latch button

1 Thumbscrew 2 Latch

1 Latch 2 Thumbscrew

12 1 2