HP StorageWorks 1510i Modular Smart Array installation and user guide (383070-002, July 2008)

conventions
document,10
text symbols,10
converting rack rails for round-hole racks,42
corrupted rmware
recovering,91
registering, note,91
customer self repair,11
D
declaration of conformity,129
device preparation
removing power,77
diagnostic tools,59
diagrams
connecting SCSI cables to SATA enclosures,
50
connecting SCSI cables to SCSI enclosures,
50
front panel,14,19
power supply LEDs,30
rear panel,15,20
SCSI I/O module LEDs,29
shipping contents,16
document
conventions,10
prerequisites,9
related documentation,9
documentation
providing feedback,12
download rmware
CLI command,84
E
electrostatic discharge notice,133
electrostatic discharge prevention notice,133
enclosure expansion
ACU,100
adding enclosures to existing MSA, 100,
100
recommended procedures,100
SMU,100
enclosures
bus and box numbers,47
installing,40
website,34
environmental requirements,36
error messages
access control conict detected,120
access control resources exceeded,120
array controller disabled,121
array controller overheated,121
array controller overheating,121
auto-upgrade failed,124
bad hard drive rmware box,117
bad scsi bus mode non-lvd device found,110
bad scsi target,110
batteries low, ash refused,124
cache data lost battery dead,114
cache hardware batteries,117
cache hardware failed and disabled,115
chassis nvram contents corrupted,111
cloning refused system halted,109
controller too old not supported,109
critical lockup detected,108
dual cache module size mismatch,114
EMU ash failed,123
Ethernet module invalid,127
Ethernet module missing,127
fan ashfailedonbox#,124
rmware ash failed,109
rmware ashfailedonbox#,123
fw version is not supported,110
hard drive failure box,117
I2C read failure,110
I2C write failure, 111
invalid congbox3<n>,bay<n>,118
invalid SCSI cabling
,126
iSCSI module bist failed,127
iSCSI module ash failed,123
iSCSI module hardware failure,127
iSCSI param load error,126
nocachemodulefound,114
no management hardware found,127
online upgrade ashing failed,109
online upgrade incomplete,110
PCI bridge ASIC self-test failure,126
PCI subsystem hardware failure,126
pilot 2 contrlr not supported,109
port <n> 10 Mb/s not supported,128
port <n> dhcp failed,127
port <n> link failure,127
port<n> conicht <ip>,128
recovery ROM autoash failed,122
redundancy failed cache Dimms mismatch,
11 4
redundancy failed cache size mismatch,112
redundancy failed rmware lockup,113
redundancy failed hardware failure, 111
redundancy failed I/O request error,113
redundancy failed mismatch rmware,112
redundancy failed mismatch hardware,112
redundancy failed no second controller,113
redundancy failed out-of-memory,113
redundancy failed PCI Bus error,113
remove other controller now,114
ROM cloning failed,122
scsi subsystem hardware failure,110
storage box EMU not responding,125
storage box fan failed,124
storage box overheated,125
storage box overheating,125
storage box power supply failed,125
system halted for cache error,116
too many volumes detected,120
uncorrected ECC memory,126
unknown I/O module detected,126
volume expansion failure,119
1510i Modular Smart Array installation and user guide
155