HP StorageWorks 1510i Modular Smart Array firmware 2.02 release notes (431339-002, March 2009)

• Added the following CLI command enhancements, limiting output display for the following com-

mands:

• show ip

• show arp

• show discovery

• show isn_server

• show acl_entry

• show target

• show portal

• show portal_group

• show iscsi_keys

• show initiator

• Added the following CLI command enhancements, adding the following new commands for Act-

ive/Active:

• show preferred_path; set preferred_path

• show auto_path_change; set auto_path_change

• show proxystats

• show taskstats

• Added the following ADU enhancements:

• Added Discovey, iSNS and iSNS server settings to ADU report.

• Added MIB statistics to ADU report.

• Converted index numbers in ADU report into readable form. (Instead of index numbers the

alias name is now displayed.)

• Fixed various formatting errors in ADU report. (Some IP addresses were previously displayed

in HEX.)

• Sort Statistics based on target/initiator information for CLI / ADU / SMU.

• Added route table support for SMU, ADU and CLI. (Route entries are sorted by dynamic/stat-

ic/data/loop-back entries.)

• Added fan-, cache-, power supply - information for external storage box to ADU report.

• In dual-controller configurations, added support for an active management port on each controller

with a unique IP address, subnet and VLAN.

• In dual-controller configurations, added support for unique iSNS settings for each controller.

• In dual-controller configurations, added support for unique SNMP trap destinations for each con-

troller.

Fixes

• HP StorageWorks MSA1510i firmware 2.00 upgrade is not recommended until further notice

(Customer Advisory c01539430)

• LUNs are no longer reset during expansion (Customer Advisory 640436).

• LUNs no longer become unavailable with I/O errors during a server reboot (Customer Advisory

640411).

• Idle sessions are now timed out after 10 minutes.

• No longer lose connectivity to storage LUNs on VMware ESX.

• Server reboots no longer cause multiple failovers.