HP StorageWorks 1510i Modular Smart Array Compatibility Guide- Controller Firmware V1.32 or Higher Only (February 2007)

ProLiant AMD® Opteron servers
DL145, DL145 G2 DC
DL385, DL385 G2 DC
DL585, DL585 G2 DC
ProLiant AMD® Opteron servers
DL365 DC
DL385 SC, DL385 DC, DL385 G2 DC
SAS
DL585 SC, DL585 DC, DL585 G2 DC
SAS
ProLiant Blade Servers
BL20p G3 SC, BL20p G3 DC, BL20p G4
DC
BL25p SC, BL25p DC, BL25p G2 DC
BL30p, BL35p SC, BL35p DC ATA
BL40p, BL45p SC, BL45p DC
BL460c DC, BL465c, BL480c
BL685c
HP Integrity servers
rx1620, rx2600,rx2620, rx3600, rx5670,
rx4640 rx6600,
rx7620, rx7640, rx8620, rx8640
HP Integrity Superdome
Not Supported
Supports most multi-vendor industry standard 32-bit Intel and AMD based (x86) servers. HP requires the Third-Party Server to be logo’d and listed on the Microsoft Windows
Server Catalog. Refer to the Microsoft website: http://www.microsoft.com/windows/catalog/server/
HP StorageWorks Division recommends that the Third-Party Server Vendor is an active member of TSANet. Refer to the TSANet website for details: www.tsanet.com
For multi-vendor industry standard x86 servers to connect to the MSA1510i – they must be running the supported version of the iSCSI initiator, operating system, HP's DSM*
and industry standard Gigabit Ethernet NICs. See compatibility guide for the MSA1510i for supported versions http://h18006.www1.hp.com/products/storageworks/msa1510i
Note: *HP’s DSM software is required for path failover with redundant controllers. Only HP’s DSM must be running on the server, and no other DSM software must be installed.
ProLiant Blade Servers
BL20p G2, BL20p G3, BL20p G4
BL25p, BL25p DC, BL25p G2
BL30p, BL35p SC, BL35p DC
BL40p, BL45p SC, BL45p DC
BL460c DC, BL465c, BL480c,
BL685c
NOTE: BL20p G1 servers are not supported