HP StorageWorks 1500/1510i Modular Smart Array chassis replacement instructions (364862-002, December 2006)

Removing the failed chassis
Prepareforthereplacement
1. If the MSA is operational, stop all access to the MSA.
2. Press and hold the power on/standby button for five seconds to
place the MSA in standby.
3. Label each cable carefully and then disconnect all of the cables.
CAUTION:
If replacing the MSA1500 chassis, use caution when handling
the Fibre Channel cables:
• Touching the end of a Fibre Channel cable will either
damagethecableorcauseperformanceproblems,including
intermittent difficulties accessing the storage.
• When a Fibre Channel cable is not connected, replace the
protective covers on the ends of the cable.
Remove the Fibre Channel (or Ethernet) I/O
modules
1. Lift the port-colored latch and pull the module out of the chassis.
NOTE:
The following illustration demonstrates removing a Fibre Channel
I/O module from the MSA1500 chassis. For the MSA1510i, the
2–Port Ethernet iSCSI I/O module is in this slot.
2
1
15498
2. Remove the other I/O module or blank.
Remove the fan modules
1. Lift the port-colored latch and pull the module out of the chassis.
2
1
15643
2. Remove the other fan module.
Remove the SCSI I/O modules
1. Lift the port-colored latch and pull the module out of the chassis.
2
1
15644
2. Remove all other SCSI I/O modules or blanks.
Remove the p
ower supply modules
1. Press the port-colored latch towards the side of the module and pull
the module out of the chassis.
1
2
15645
2. Remove the other module.
Remove the controllers
1. Press the controller thumb latch to release the latch handle, and
then rotate the latch handle out.
2
1
15492
2. Grasp the latch handle and pull the controller out of the chassis.
3. Remove the other controller or blank.
Page 2