HP StorageWorks Power Supply/Blower Modular Smart Array Replacement Instructions (April 2004)

Installing a power supply

1. Lift up on the module latch (1, Figure 5) and slide the power

supply into the enclosure until it is fully seated.

Figure 5: Installing a power supply

2. Connect the power cord to the power supply and engage the

cord lock.

Verifying proper operation

After replacing the power supply or blower, verify that the

component is operating normally using the following methods:

■ Make sure the blower begins operating immediately.

■ The status LED should be On.

■ Controller LCD panel should no longer indicate a power

supply/blower failure.

Returning the failed component

Please follow the return instructions provided with the new

component.

0010a