HP StorageWorks MSA SAN Switch 2/8 Installation Guide (December 2002)

29MSA SAN Switch 2/8 Installation Guide
3
Configuring the MSA SAN
Switch 2/8
The process of configuring the MSA SAN Switch includes the initial process of
changing the factory-set IP address to a valid IP address for your environment.
The IP address must initially be entered using the CLI.
After the IP address is set, additional parameters must be entered, but they may be
entered through either the CLI or the Web Tools.
This chapter discusses:
■ Requirements, page 30
■ Entering Initial Configuration Settings through the CLI, page 31
■ Connecting the MSA SAN Switch 2/8 to the Ethernet Network, page 35
■ Completing MSA SAN Switch 2/8 Configuration, page 36
■ Verifying Operation, page 36