HP StorageWorks MSA SAN Switch 2/8 Installation Guide (December 2002)

About the MSA SAN Switch 2/8
16 MSA SAN Switch 2/8 Installation Guide
MSA SAN Switch 2/8 Hardware Features
MSA SAN Switch hardware support includes:
■ Embedded design specifically for the MSA1000
■ Hot-pluggability
The switch can be installed or replaced without power cycling the MSA1000.
When adding or replacing a switch, allow sufficient time to complete the
POST tests and the configuration tasks before using.
■ Redundancy
In redundant fabric configurations, you can install two MSA SAN Switches to
support the redundant MSA1000 controllers.
■ Single chip ASIC switch design
■ Eight ports
— Seven available 2-Gb/s Fibre Channel ports are compatible with Small
Form Factor Pluggable (SFPs) transceiver interconnects (Port 1 through
Port 7)
— One internal port (Port 0) for interfacing with the MSA1000 Array
Controller, using F_Port protocol
■ Per port automatic negotiation to the highest possible speed
■ One IEEE compliant 10/100 Mb/s Ethernet management port; able to
auto-sense a straight-through cable or crossover cable configuration
■ One DB-9 serial port
■ A total of 15 LEDs:
— One Switch Readiness LED
— One port status LED for each of the seven available ports
— One port speed LED for each of the seven available ports