HSG80 ACS Solution Software V8.6 for IBM AIM Installation and Configuration Guide

Installing and Configuring the HS-Series Agent 4–13
Specify an access device to query for information (e.g. "hdisk5") : hdisk12
The following subsystem has been found:
Controller type : HSG80
Firmware version : YB02
Serial numbers : ZG94213498, ZG00314890
EMU type : None installed
Would you like to add this subsystem to the 'storage.ini' file? [Y,n] :
y
Enter a name for this subsystem : hsg80
Enter a monitoring interval, in secs
(0 => no monitoring, default is 300) : 300
Would you like to add another subsystem? [y,N]
n
This section of the script asks if you want the agent to notify a specific person via e-mail if
there is an error or informational message. The first part asks for the e-mail address. This
can be any valid e-mail address or it can be a local user on that machine (for example,
root). The second part asks what level of notification you want this e-mail address to
receive.
1 - Only notification for serious errors that need immediate attention will be sent.
2 - Notification for serious errors and warning messages will be sent.
3 - Notification for serious errors, warning messages, and informational messages will
be sent.
The install asks you to confirm your entries and provides you the opportunity to enter
another e-mail address. At the end of this part, it will display a list of all the e-mail
addresses you have configured as well as their notification levels.