HSG80 ACS Solution Software V8.6 for IBM AIM Installation and Configuration Guide

4–10 HSG80 ACS Solution Software Version 8.6 for IBM AIX Installation and Configuration Guide
Adding a Client system
-------------------------
Enter the host name of the Client system : <host name of client system>
Enter the subsystem access privilege (which controls the level of access
a client has for communicating with the storage subsystems).
The possible options are:
0 = Navigation Tree monitoring Only
1 = Navigation Tree and Storage Window monitoring Only
2 = Navigation Tree monitoring, Storage Window monitoring and Configuration
Enter Access Level (0, 1, 2) : <enter 0, 1, or 2>
The Agent server can notify a client when an error condition occurs.
Notification schemes available are:
0 = No Error Notification
1 = Notification via a TCP/IP Socket
2 = Notification via the SNMP protocol
3 = Notification via both TCP/IP and SNMP
Enter Error Notification Level (0, 1, 2, 3) : <enter 0, 1, 2, or 3>
Adding client--
name: dolt
access level: 2
error notification: 3
Is this information correct? [Y,n]
Would you like to add another client? [y,N] <
y if you have more than one client, n if you do
not>
This section of the install enables you to add RAID subsystems to monitor. The
installation provides a list of disks that the agent can use to communicate with the RAID
subsystem. When the install asks you for an access device, enter a disk from the list of