Compaq StorageWorks HSG60 ACS Solution V8.6 for SGI IRIX Installation and Configuration Guide

Installing and Configuring the HS-Series Agent 4–7
The Agent program is installed. It was automatically started if you typed Y to start the
Agent during the installation. It will restart automatically after a system restart or if it
stops for any reason.
How do you want a CC Agent server to notify a
client when an error condition occurs?
Notification schemes available are:
0 = No Error Notification
1 = Notification via a TCP/IP Socket
2 = Notification via the SNMP protocol
3 = Notification via both TCP/IP and SNMP
Selecting this option results in:
0 = No notification over network, but local
notification through email and an entry in the CC
Agent error log file.
1 = Notification messages sent to the GUI and
local notification sent through email and an entry
in the CC Agent error log file.
2 = Notification messages sent to the SNMP
monitor and local notification sent through email
and an entry in the CC Agent error log file.
3 = Notification messages sent to the GUI, the
SNMP monitor, and local notification sent through
email and an entry in the CC Agent error log file.
Names of your subsystems. Specify unique names for each subsystem in your
configuration.
*The character special file name for accessing the
storage system.
Enter the device name that your operating system
assigned to the communications logical unit that
you enabled in Appendix B.
From the choices displayed select the device that
corresponds to the “HSGCCL”
Do you want email notification of errors or failures
on the RAID subsystem?
*If yes to email notification, specify email address
and notification level.
1 = Fatal error only
2 = Warning and fatal errors
3 = Info, warning and fatal errors
Enter Y to receive email and syslog notification.
Enter N for syslog notification only.
*Enter email address and notification level for each
user.
1 = Notification for serious errors, which require
immediate attention.
2 = Notification for serious errors and warning
messages.
3 = Notification for serious errors, warnings and
informational messages.
Table 4–3 Information Required for Install Program Prompts (Continued)
Information Required to Complete Installation How to Respond