Compaq StorageWorks HSG60 ACS Solution V8.6 for SGI IRIX Installation and Configuration Guide

Installing and Configuring the HS-Series Agent 4–5
Installing and Configuring the Agent
IMPORTANT: Copy the installation and configuration script to a temporary directory before
beginning this installation. For instructions, see Chapter 3.
The Agent will automatically start when you install it and will restart automatically if it
stops for any reason.
1. Log on to the host system as root (superuser). You must have access to the superuser
(root) account to perform this installation.
2. Change to the directory to which you copied the installation and configuration script
from the CD-ROM. For example, if you installed the installation and configuration
script to the /tmp/HSG directory, you would enter the following:
# cd /tmp/HSG80
3. To start the StorageWorks installation and configuration script, enter the following:
# ./stgwks_sgi.sh
The StorageWorks and Command Console Agent Installation and Configuration menu
appears.
4. To install the Agent, select option 3.
5. Follow the text-based prompts and enter the appropriate information.
NOTE: If you entered Y to start the Agent during the installation, the Agent starts. Its default is to
restart automatically after a system restart or if it stops for any reason.
6. To remove the temporary directory, enter the following:
# rm -r /tmp/HSG80
Table 4–3 Information Required for Install Program Prompts
Information Required to Complete Installation How to Respond
Target directory for installation /usr/stgwks is the directory where StorageWorks
will be installed. It contains the software copied in
Chapter 3. The directory must have a minimum of
4 MB of space available.
*Port that the Command Console Client uses to
communicate with the Command Console Agent
for RAID subsystem configuration and
maintenance.
*Default is 4998.
If the default port is already used, press N and
specify a new port.