Compaq StorageWorks HSG60 ACS Solution V8.6 for SGI IRIX Installation and Configuration Guide

Chapter 6
Configuration Example Using CLI
This chapter presents an example of configuring a particular storage subsystem using the
CLI. The CLI configuration example shown assumes:
■ A normal, new controller pair, meaning:
❏ NODE ID set
❏ No previous failover mode
❏ No previous topology set
■ Two single-bus model 4214R disk enclosure shelves
■ PCMCIA cards installed in both controllers
A storage subsystem example is shown in Figure 6–1. The example system contains three
non-clustered Irix hosts, as shown in Figure 6–2. The resulting virtual system, from the
hosts’ point of view, is shown in Figure 6–4.
Figure 6–1 shows an example storage system map for the 4214R enclosure. Details on
building your own map are described in Chapter 2. Templates to help you build your
storage map are supplied in Appendix A.