Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Sun Solaris Installation and Configuration Guide

Preparing the Host System 3–3
Perform the following steps to install the system Manager packages onto the hard disk:
1. Mount the CD-ROM.
2. Load the CPQptisp package (optional, only required to support legacy RAID systems
attached to an SBS-450 SCSI adapter).
3. Load the CPQfcraid package.
4. Configure WWPN/target bindings (edit your sd.conf file).
5. Restart your computer.
6. Label (format) LUNs and create file systems if required.
7. Configure the Agent to ensure subsystems are monitored (see Chapter 4).
Verifying/Installing Required Versions
To prepare for your RAIDManager software installation, complete the following steps:
1. Back up your entire system according to your normal procedure.
2. Select a system user with superuser privileges (for example: root) as the RAID
administrator.
3. Log in as the RAID administrator.
4. To find a file system with at least 500 KB free space, type:
# df -k
5. Choose a directory in which to install the SWCC software. The default is /opt, however
you may specify any directory. You will need to know this when running the
installation script.
NOTE: The “base directory” (referred to when installing Agent) will have a “steam”
subdirectory created under it. This is the directory where the Agent files will be installed.
CPQptisp The HBA driver for the CPQ/PTI SBS450 SCSI adapter. This should only be used
when the Sun server is interfaced with existing SCSI RAID systems (RA410, RA450,
RA7000), that are attached to a CPQ/PTI SBS-450 SCSI adapter.
NOTE: This driver does not support Solaris in 64-bit mode. To use the
SB5S50 SCSI adapter under 64-bit Solaris, set the adapter to Sun
emulation mode.
Table 3–1 StorageWorks Solution Software Packages (Continued)
Package Description