Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Sun Solaris Installation and Configuration Guide

3–2 HSG60 ACS Solution Software Version 8.6 for Sun Solaris Installation and Configuration Guide
CAUTION: Protect the host bus adapter board from electrostatic discharge by wearing
an ESD wriststrap. DO NOT remove the board from the antistatic cover until you are
ready to install it.
it.
You need the following items to begin:
■ Host bus adapter board
■ The computer hardware manual
■ Appropriate tools to service the computer
The host bus adapter board plugs into a standard PCIor Sbus slot in the host computer.
Refer to the system manual for instructions on installing expansion boards
IMPORTANT: Do not power up anything yet. For the FC switches to autoconfigure, power up
equipment in the sequence described in the next section. Also, the controllers in the subsystem
are not yet configured for compatibility with Sun Solaris.
The StorageWorks Solution Software consists of the packages as shown in Table 3–1.
Table 3–1 StorageWorks Solution Software Packages
Package Description
CPQfcraid Agent software and system updates required for RAID system operation. This
package should always be installed.
CPQfcaw The HBA driver for the CPQ/JNI FC64-1063Fibre Channel 64-bit Sbus. adapter. This
package should be loaded when a CPQ/JNI SWSA4-SC adapter is installed in the
server.
CPQfca The HBA driver for the CPQ/JNI FC-1063 Fibre Channel 32-bit Sbus adapter. This
package should be loaded when a CPQ/JNI SWSA4-SB adapter is installed in the
server.
CPQfcaPCI The HBA driver for the CPQ/JNI FCI-1063 32-bit PCI bus adapter. This package
should be loaded when a CPQ/JNI SWSA4-PC adapter is installed in the server.