Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Sun Solaris Installation and Configuration Guide

6–16 HSG60 ACS Solution Software Version 8.6 for Sun Solaris Installation and Configuration Guide
Loop Configuration(s)
NOTE: This procedure assumes that the Solaris platform kit is being loaded onto the system
and a specific mode of operation is being selected.
1. Load the Solaris Platform kit and select the Loop mode for the driver when prompted.
By default, the Targets that are associated with the adapter are 64, 65.
2. Reboot the system. This is the normal reboot after driver/kit installation.
3. Complete the installation as documented with /opt/steam/bin/install.sh
4. If the server is in a hub configuration with multiple subsystems:
❏ verify that the controller is configured for loop mode and verify that the specific,
desired ALPAs are assigned to each destination controller port using the CLI.
❏ verify that the server has the specific ALPAs assigned as Targets for the adapter by
using /opt/steam/bin/Config.sh - Option 20 Add/Change Adapters, Option 1,
View adapters.
5. In cases that require a change of ALPAs at the server a reboot of the system will be
required. The command reboot -r should be used to force a reconfiguration boot.
6. After reboot, the intended Targets should be visible under the
format listing. This
assumes that at least one unit has been created on the subsystem(s).
Fabric Configuration(s)
NOTE: This procedure assumes that the Solaris platform kit is being loaded onto the system
and a specific mode of operation is being selected.
1. Load the Solaris Platform kit and select the Fabric mode for the driver when prompted.
There are no default WWPNs so the software will prompt for the specific WWPNs.
When entering the values, case is not important, but the hyphenation is.
2. Reboot the system. This is the normal reboot after driver/kit installation.
3. Complete the installation as documented with /opt/steam/bin/install.sh
4. Verify that the destination subsystem(s) controller(s) are configured for fabric mode
using the CLI.
5. If the Targets cannot be seen under the
format command then a reboot -r of the server
will be required. (This assumes that some change was made to the server or controller.)