Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Sun Solaris Installation and Configuration Guide

Fibre Channel: Considerations for Both Loop and Fabric Environments 6–9
Fabric. These values are used in conjunction with the
WWPN ( see below )
Unlike loop mode, these Targets are arbitrary; that is, they
do not correspond to an ALPA. Targets 64 and 65 are simply
used for compatibility with loop mode.
LUN: lun=0
The default logical units of 0..15 have been supplied and
may be extended to a total of 64. (See Adapter
Configuration Menu below.)
Fabric Port: wwpn="5000-1fe1-0000-13f1";
The WWPN that Solaris will attempt to bind to. This
WWPN identifies the first port on the HSG60 controller.
The /opt/steam/bin/config.sh Utility
When installing the StorageWorks RAID Manager Software, a utility script file is loaded
onto the system. While installing the kit, the user may choose an installation directory or
take the default, /opt directory These discussions assume that the default directory was
used (/opt/steam).
This utility script has many options and they are documented in the Solaris Getting Started
documentation. Our attention here is the ability to configure either loop ALPAs or fabric
WWPNs. Both are accomplished with the /opt/steam/bin/Config.sh script.
The menu is shown below.
The menu is shown below.
---- RAID array V8.6 Configuration Menu ----
Agent Admin Options Storage Subsystem Options
------------------- -----------------------------
1) Change Agent Password 12) View Subsystems
2) Change SNMP Enterprise OID 13) Add a Subsystem
3) Start/Stop the Agent 14) Remove a Subsystem