Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Sun Solaris Installation and Configuration Guide

5–20 HSG60 ACS Solution Software Version 8.6 for Sun Solaris Installation and Configuration Guide
Assigning a Unit Number to a Partition
To assign a unit number to a partition, use the following syntax:
ADD UNIT UNIT-NUMBER STORAGESET-NAME PARTITION=PARTITION-NUMBER
For example:
To assign unit D100 to partition 3 of mirrorset mirr1, use the following command:
ADD UNIT D100 MIRR1 PARTITION=3
Configuration Options
Changing the CLI Prompt
To change the CLI prompt, enter a 1- to 16- character string as the new prompt, as follows:
SET THIS_CONTROLLER PROMPT = “NEW PROMPT”
If you are configuring dual-redundant controllers, also change the CLI prompt on the
“other controller.” Use the following command:
SET OTHER_CONTROLLER PROMPT = “NEW PROMPT”
It is suggested that the prompts reflect something about the controllers. For example, if the
subsystem is the third one in a lab, give the top controller a prompt like LAB3A and the
bottom controller, LAB3B.
Mirroring cache
To specify mirrored cache:
SET THIS MIRRORED_CACHE
Adding Disk Drives
If you add new disk drives to the subsystem, the disk drives must be added to the
controllers’ list of known devices:
■ To add one new disk drive to the list of known devices, enter the following command:
ADD DISK DISKNNNNN P T L