Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Sun Solaris Installation and Configuration Guide

5–4 HSG60 ACS Solution Software Version 8.6 for Sun Solaris Installation and Configuration Guide
❏ 1 stop bit
❏ no parity
5. Press Enter. A copyright notice and the CLI prompt appear, indicating that you
established a local connection with the controller.
Cabling a Single controller
The cabling for a single controller is shown in Figure 5–2.
NOTE: It is a good idea to plug only the controller cables into the switch. The host cables are
plugged into the switch as part of the configuration procedure (“Configuring a Single Controller
Using CLI,” page 5–4).
Figure 5–2. Single controller cabling
Configuring a Single Controller Using CLI
To configure a single controller using CLI involves the following processes:
■ Verify the Node ID and Check for Any Previous Connections.
■ Configure Controller Settings.
■ Restart the Controllers.
1 Controller
2 Host port 1
3 Host port 2
4 Cable from the switch to the host Fibre Channel adapter
5 FC switch
CXO6881B
1
5
5
3
2
4
4