Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Linux X86 and Alpha Installation and Configuration Guide

5–4 HSG60 ACS Solution Software Version 8.6 for Linux X86 and Alpha Installation and Configuration Guide
3. Apply power to the storage subsystem.
4. Open the file /etc/uucp/port.
5. Configure the computer or terminal as follows:
❏ 9600 baud
❏ 8 data bits
❏ 1 stop bit
❏ no parity
If these lines are not in the port file for the appropriate serial port, enter them and save
the file.
6. Create /dev/ttys0
7. Enter the following commands:
cd /dev
./MAKEDEV ttyS0
8. Open a Terminal Window from the Desktop Program menu.
9. Start the Call Up Program (CU); at the prompt enter the following command:
cu -p com1
10. Press Enter. A copyright notice and the CLI prompt appear, indicating that you
established a local connection with the controller.
Cabling a Single controller
The cabling for a single controller is shown in Figure 5–2.
NOTE: It is a good idea to plug only the controller cables into the switch. The host cables are
plugged into the switch as part of the configuration procedure (“Configuring a Single Controller
Using CLI,” page 5–5).