Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Linux X86 and Alpha Installation and Configuration Guide

4–6 HSG80 ACS Solution Software Version 8.6 for Linux X86 and Alpha Installation and Configuration Guide
Your Command Console LUN for this controller has a SCSI ID of “0,0,0”. After
performing a /dev/MAKEDEV sgk, you will get the following output from the command
scsi_info /dev/sgk:
SCSI_ID=”0,0,0”
MODEL=”DEC HSGCCL”
FW_REV=”V86”
NOTE: At this point the sd device sdk maps to the sg device sgl.
Configuring the Agent
There are two ways to configure your Agent:
■ Install.sh–This utility is usually used for first-time configuration or upgrades. It
guides you through the configuration of your Agent. It also identifies and upgrades any
old Agent configuration files from previous RAID Manager packages. See
"Configuring the Agent with Install.sh (for First-time Configurations)" for details.
■ Config.sh–A menu-based administration tool that is usually used to modify your
Agent configuration after installation. It provides more options than install.sh, so
it is recommended for advanced users or users with unique configuration needs. It can
also be used for first-time configuration. See "Configuring the Agent with RAID Array
V8.6 Configuration Menu"for instructions on running Config.sh
.
Configuring the Agent with Install.sh
(for First-time Configurations)
For first-time configurations, run the install.sh script from the $basedir/steam/bin
directory (usually /usr/local/steam/bin). This script will guide you through the following
actions:
■ Adding a subsystem entry
■ Adding a Client entry
■ Creating a password
■ Setting up email notification
■ Starting the Agent
1. To change directories, enter the following command:
#cd /usr/local/steam/bin