Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Linux X86 and Alpha Installation and Configuration Guide

Configuration Procedures 5–21
For example:
To assign unit D4 to DISK20300, use the following command:
ADD UNIT D4 DISK20300
Assigning a Unit Number to a Partition
To assign a unit number to a partition, use the following syntax:
ADD UNIT UNIT-NUMBER STORAGESET-NAME PARTITION=PARTITION-NUMBER
For example:
To assign unit D100 to partition 3 of mirrorset mirr1, use the following command:
ADD UNIT D100 MIRR1 PARTITION=3
Configuration Options
Changing the CLI Prompt
To change the CLI prompt, enter a 1- to 16- character string as the new prompt, as follows:
SET THIS_CONTROLLER PROMPT = “NEW PROMPT”
If you are configuring dual-redundant controllers, also change the CLI prompt on the
“other controller.” Use the following command:
SET OTHER_CONTROLLER PROMPT = “NEW PROMPT”
It is suggested that the prompts reflect something about the controllers. For example, if the
subsystem is the third one in a lab, give the top controller a prompt like LAB3A and the
bottom controller, LAB3B.
Mirroring cache
To specify mirrored cache:
SET THIS MIRRORED_CACHE