HP StorageWorks Enterprise File Services WAN Accelerator Manager 3.0.2 release notes (AG424-96003, March 2007)

6
Setting the system date/time
When setting the system date/time in the web-based GUI, if the date and time is significantly off when set
to the current date and time, the GUI logs the user off. Should this occur, log back in, and the date is now
correct. You can then set the time.
Refreshing web GUI pages
When configuring items through the web GUI, at times a browser error may be returned stating Page not
found. When this occurs, press the Refresh button in the web browser, and the page often returns
correctly.
HP System Management Homepage
When logging in to the HP System Management Homepage, use the admin login only; do not attempt to
use a Radius or TACACS+ login.
The login page of the HP System Management Homepage does not allow a blank password. Set the
admin account password before attempting to login to the HP System Management Homepage.
When sending test traps from the HP System Management Homepage (Settings > SNMP Webagent >
SNMP Configuration), only version 1 traps are sent. Set a version 1 trap destination using the general
system Management Console (Setup > Reports > SNMP Trap Receivers) before attempting to send a test
trap using the HP System Management Homepage.
HP Integrated Lights-Out network settings
Modifying settings using the web-based interface of the HP Integrated Lights-Out (iLO) Network Settings
page (Administration > Network Settings) can result in the system locking up. If Automatic Server Recovery
(ASR) is enabled, the system will reboot after the ASR timeout value (see the system's ROM-Based Setup
Utility (RBSU) to determine if ASR is enabled.) To avoid this, access the WAN Accelerator Manager
command-line interface (CLI) and issue the following commands prior to modifying network settings on
iLO:
enable
configure terminal
hp agents stop
Then, modify the network settings on iLO. After you have finished modifying the network settings, start the
HP agents using the CLI:
hp agents start
An alternative is to modify the iLO settings using the iLO RBSU, available during system boot. See the HP
Integrated Lights-Out home page at http://www.hp.com/servers/lights-out
for information about iLO, and
the HP ROM-Based Setup Utility User Guide on the documentation CD for information about RBSU.
Shutting down the system
When shutting down the system using the web-based interface or the command-line interface, the system
will not automatically power down. A few minutes after the shutdown command is issued, the system goes
into a mode that is safe to power down by using the power button.