HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Installation and Configuration Guide (November 2005)

HP STORAGEWORKS EFS WAN ACCELERATOR INSTALLATION AND CONFIGURATION GUIDE 41

2 - INSTALLING AND

ONFIGURING THE HP EFS

8. To configure the domain name for the system, enter the domain name at

the system prompt. For example:

Step 7: Domain name? mydomain.com

If you configure a domain name, you can enter host names in the system

without the domain name.

9. To assign a new password to the administrator user (admin), type a

password at the system prompt. For example:

Step 8: Admin password? xxxyyy

HP strongly recommends that you change the default password at this

time. The password must be minimum of 6 characters. The default

administrator password is password.

10. If you have already configured another HP EFS WAN Accelerator, you are

given the option to copy your configuration settings to this appliance. To

copy configuration settings, type yes at the system prompt. If you do not

need to copy a configuration, type no at the system prompt. For example:

Step 9: Copy config from another site? no

11. To set the speed on the primary interface (that is, the HP EFS WAN

Accelerator), type a value at the system prompt. Make sure this value

matches the settings on your router or switch. The default value is auto.

For example:

Step 10: Set the primary interface speed? 100

12. To set the duplex mode on the primary interface, type a value at the system

prompt. Make sure this value matches the settings on your router or

switch. The default value is auto. For example:

Step 11: Set the primary interface duplex? [auto] full

13. You are given the option to activate in-path support. Type no at the system

prompt. For example:

Step 12: Would you like to activate the in path configuration? no

14. To activate an out-of-path configuration, type yes at the system prompt.

For example:

Step 13: Would you like to activate the out-of-path configuration? [no]

yes