HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Installation and Configuration Guide (November 2005)

20 1 - OVERVIEW OF THE HP EFS WAN ACCELERATOR
4. On HP EFS WAN Accelerator-4, at the system prompt, enter the following
set of commands:
SH4 (config) # sport peer 0.0.0.0 version min 5
SH4 (config) # sport peer 0.0.0.0 version max 5
SH4 (config) # sport peer <HP EFS WAN Accelerator-1 IP addr> version min
6
SH4 (config) # sport peer <HP EFS WAN Accelerator-1 IP addr> version max
6
SH4 (config) # sport peer <HP EFS WAN Accelerator-2 IP addr> version min
6
SH4 (config) # sport peer <HP EFS WAN Accelerator-2 IP addr> version max
6
SH4 (config) # sport peer <HP EFS WAN Accelerator-3 IP addr> version min
6
SH4 (config) # sport peer <HP EFS WAN Accelerator-3 IP addr> version max
6
SH4 (config) # write memory
SH4 (config) # restart
If you upgrade the remaining HP EFS WAN Accelerators in your network (HP
EFS WAN Accelerator-5 through HP EFS WAN Accelerator-10) and there are
no more 1.2 HP EFS WAN Accelerators in your network, you can remove all
the version configurations on HP EFS WAN Accelerator-1 through HP EFS
WAN Accelerator-4.
1. Connect to the Management Console on each HP EFS WAN Accelerator.
2. Install the 2.1 image in the Setup: Software Upgrade page.
3. Save the current configuration in the Setup: Configuration Manager page.
4. Reboot the HP EFS WAN Accelerator in the Setup: Reboot Appliance page.
5. Connect to the CLI on each of the 3 HP EFS WAN Accelerators you
originally upgraded (that is, HP EFS WAN Accelerator-1, HP EFS WAN
Accelerator-2, HP EFS WAN Accelerator-3, HP EFS WAN Accelerator-4).